Service manual

4
5
Your compactor has been designed to require
minimum space without loss of capacity whether
free-standing or built-in.
Free-Standing
As shipped, the compactor is only configured for
built-in installations. This appliance can be converted
from built-in to free-standing with the use of Toe Kick
Accessory Kit Model 15TCTK (sold separately).
If additional cord length is required for free-standing
installation, remove the cord clamp and wire tie on the
back of the unit.
CAUTION
Failure to use Toe Kick Assembly Kit Model 15TCTK
in a free-standing installation may cause the
compactor to be unstable during operation.
Section A – Installation
Built-in Installation
MOUNTING STRAPS
Two under-counter mounting straps are provided. Use
these straps to secure the compactor to the underside
of a countertop.
Fasten the slotted end of the straps to the compactor
using the holes in the top of the compactor cabinet as
shown.
NOTE: When installation compactor under granite or
solid surface countertops, bend the mounting straps
so they can be secured to the adjacent cabinetry.
UNDER-COUNTER OPENING
The compactor requires an under-counter opening 15-in.
wide, 34-1/2-in. high, and 22-in. deep.
Plan to provide an electrical outlet in the opening that
meets all applicable electrical codes and requirements.
See “Grounding Instructions” on Page 2 for specific
information.
TOP OF
COMPACTOR
FRONT OF
COMPACTOR
Opening
15" Wide
34-1/2" High
22" Deep
15" W
34
1
/2" H
22" D
12" MIN
ELECTRICAL
OUTLET
CAUTION