User`s guide

38
There are a few notes to be familiar with prior to running
the Disk Erase operation.
1. Both hard disk drives need to be Ultra DMA
compatible.
2. You can connect two hard disk drives to the Disk
Jockey to check them both simultaneously.
3. If you are checking only one hard disk drive please
make sure that you connect it to the Drive 1 port.
Data Erase
1. Turn the Mode Select switch to Data Erase mode
(either x1 or x3)
2. Connect the hard disk drive that you want to erase
to the Drive 1 port (if you are checking two disk
drives you can connect hard disk drive two to the
Drive 2 port).
3. Push down on the Blue power button firmly. The
first push of the button will apply power to the hard
disk drive(s) and it will begin to rotate, or spin up.
4. Push down on the Blue power button once again
and the Data Erase will begin.
5. Progress status of the Data Erase can be visually
seen via the LED. The LED is labeled as “LED
1” and is located to the right of “Access 2”
and “Access 1.” The visual representation of
the progress on all Disk Jockey modes (where
applicable) can be viewed based on the following
chart: