User`s guide

seen via the LED. The LED is labeled as “LED

1” and is located to the right of “Access 2”

and “Access 1.” The visual representation of

the progress on all Disk Jockey modes (where

applicable) can be viewed based on the following

chart:

5. At the end of the Disk Check Mode the buzzer

will sound signaling completion and the LED will

continue to stay on, 3 seconds later power will be

turned off automatically.

MODE 6 AND MODE 7 (DATA ERASE X1, X3)

Mode’s 6 and 7 are Data Erase x1 (one pass) and Data

Erase x3 (three pass) respectively. These two modes

have been grouped together because the operation and

explanation of the modes is identical except for the fact

that the Data Erase x3 (three pass) complete three passes

of writing zeros to the hard disk drive. Data that had

previously been written to a disk that has been erased

using the Data Erase x3 cannot be easily recovered. The

Data Erase x1 (1 pass) is also often referred to as a “quick

erase.”

NOTE – the Data Erase x3 will take three times as long to

complete as the Data Erase x1 as the hard disk drive(s) are

literally being erased three separate times.

In Disk Erase Mode the Disk Jockey IS NOT connected to

the computer.