User`s guide

36
hard disk drives are attached to the Disk Jockey. The Disk
Jockey will check the hard disk drives for disk errors and
will report to the user the status of the drives via audible
alert signals. In Disk Check Mode the Disk Jockey IS NOT
connected to the computer.
There are a few notes to be familiar with prior to running
the Disk Check operation.
1. Both hard disk drives need to be Ultra DMA
compatible.
2. You can connect two hard disk drives to the Disk
Jockey to check them both simultaneously.
3. If you are checking only one hard disk drive please
make sure that you connect it to the Drive 1 port.
Disk check mode operation
1. Turn the Mode Select switch to Disk Check mode
(Mode 5)
2. Connect the hard disk drive that you want to check
to the Drive 1 port (if you are checking two disk
drives you can connect hard disk drive two to the
Drive 2 port).
4. Push down on the Blue power button firmly. The first
push of the button will apply power to the hard disk
drive (s) and it will begin to rotate, or spin up.
5. Push down on the Blue power button once again
and the Disk Check will begin.
4. Progress status of the Disk Check can be visually