User`s guide

35
1. Turn the mode select switch to the Compare Mode
2. Connect the hard disk drive that you want to
“compare from” to the Drive1 port and connect the
hard disk drive that you want to “compare to” to
the Drive2 port.
3. Push down on the Blue power button firmly. The first
push of the button will apply power to the hard disk
drives and they will begin to rotate, or spin up.
3. Push down on the Blue power button once again
after the Power light has turned from red to green
indicating that the drives have spun up and are
ready to be used and the disk Compare will begin.
Caution – this mode compares Disk 1 to Disk 2 so
please verify that this is what you want to do prior to the
operation.
4. Progress status of the Compare can be visually seen
via the Power light as discussed in previous mode
operations. The visual representation of the progress
on all Disk Jockey modes (where applicable) can be
viewed based on the following chart:
5. At the end of the Compare Mode the buzzer
will sound signaling completion and the led will
continue to stay on, 3 seconds later power will be
turned off automatically.
MODE 5 (DISK CHECK)
Mode 5 is Disk Check mode. In this mode, one or two