User`s guide

33
The Power light (located on the side of the Disk
Jockey near the Drive1 port) will be red, once it
turns to green, the Disk Jockey is ready to begin the
copy (see step 4).
4. Push down on the Blue power button once again
and the disk-to-disk copy will begin.
WARNING - Copy mode will over write all of the data
on the hard disk drive attached to the Drive2 port. It is not
necessary to format or erase the disk on the Drive2 port
prior to copying.
5. Progress status of the copy can be visually seen
via the Power light. The Power light will blink a
series of on/off patterns based on the progress of the
function being used. The visual representation of
the progress on all applicable Disk Jockey modes
can be viewed based on the following chart:
6. When the copy has completed you will hear an
audible buzzer to indicate that the job is finished.
The LED will remain on with a solid green
color. Approximately 3 seconds after the copy
has completed the power to the Disk Jockey
will automatically turn off. You can leave the
copy function running and leave the Disk Jockey
unattended and it will automatically shut off upon
completion.
If you would like to verify that the data has been
successfully copied you can go to the compare mode (Mode