User`s guide

Step-by-step example of a Disk Copy

Throughout the rest of the manual you will be given more

detailed information on the various modes of the Disk

Jockey. Overwhelmingly, however, the Disk Jockey is used

as a portable hard disk duplicator. The following step-by-

step guide takes you through the copy process using the

Disk Jockey. Once you have a feel for how the Disk Jockey

works in copy mode, you will most likely be able to work

the Disk Jockey in any mode.

1. Make sure power is off or disconnected.

2. Jumper source drive as Master. Jumper target drive as

Master.

3. Connect correct source cable to Source side of DJ,

and corresponding end to source drive. Verify pin

#1 matches red cable stripe.

4. Connect correct target cable to Target side of DJ,

and corresponding end to target drive. Verify pin #1

matches red cable stripe.

5. Turn mode switch to Mode 3.

6. Connect power adapter to DJ.

7. Firmly push the Blue Button 1 time.

8. The Power light will be red. The Disk Jockey will

spin up the drives and the light will turn from red to

green.

9. Firmly push the Blue Button a second time. The

copy process will begin, the Power light will begin