User`s guide

19
present,” simply set the drive to master.
5. When attaching the power cable connector and flat
cable connector to the hard disk drive, make sure
that the orientation is correct. If you try to force it in
it could cause damage to the unit.
6. Always place the bare hard disk drive mechanisms
on the included electrostatic mats when connected
to the Disk Jockey.
7. A hard disk drive is a precision electromechanical
piece of equipment, make sure that you do not
directly touch the printed circuit board of the hard
disk drive or the connector pins directly with your
hands.
8. While the hard disk drive is in operation (ex. copy,
erase, etc.) do not touch the flat cable or the power
cable.
9. Do not try to move the unit with the hard disk
drives attached to it, always remove the cable from
the hard disk drive(s) before moving the unit. Do
not move the unit by pulling on the flat cable or the
power cable.
10. Hard disk drives may get very hot during operation.
Please take caution when touching the hard disk
drives after completing an operation as they may
remain hot for some time after.
NOTE – When using the modes in which the Disk Jockey
is connected to a computer (standard mode, spanning or
mirroring) you can only connect the Disk Jockey using one
interface, either USB or FireWire. Do not connect both a