User Guide

Connections and Setup
103
Connecting to the TV (TV1 Outputs)
YPbPr Connections
The YPBPR (component) connections provide high-quality video to your HDTV or HD
monitor. If an HDMI audio/video connection between your receiver and TV is unavailable
or not applicable, then you should use component video with separate audio.
1 Connect between the YPBPR component video connections on the receiver and the TV
using component (usually red/green/blue) video cables.
2 Connect audio (red and white) RCA-type cables between the receiver AUDIO OUTPUTS and
audio input connections that go with the YPbPr connectors on your HDTV or monitor.
3 If you do not see a picture, change the resolution setting on the receiver. Use the steps
below and Setting Up to Display in HD on the next page.
4 Turn up the volume on your HDTV and confirm you have sound. Check the RCA-type
connections if you don’t have sound.
No Picture on Your TV
This section will help you make a picture appear on your TV in case you could not do so in
the previous sections.
1 Connect the three RCA-type cable connections (yellow for video and red/white for audio)
between the receiver TV1 O
UT and the TV.
2 Make sure that both the receiver and your TV are turned on (not in standby or power-
saving mode).
3 Make sure your TV is set to view the RCA-type audio/video inputs or source. Look on the
back of your HDTV or consult your HDTV user’s guide for more information.
4 Change the receiver’s HDTV settings, as described on page 104.
5 Switch to your TV to display from the HD inputs (HDMI or component video) that you
selected in the previous sections. If you have a picture, you are finished.
6 Repeat steps 4 and 5 until your TV displays a video image from the receiver.
3
4
Connect receiver
and monitor with
YPbPr Component
connections
Turn monitor
and receiver on
and confirm
picture
Confirm
sound and
volume
2
Connect receiver and
monitor with Audio cables
1
AUDIO
L
R