User Guide

Operating Other Devices

Chapter 10

Checking the Device Codes

You can find out what device code you’ve set for each remote control mode (TV, DVD, and

AUX).

Press and hold the appropriate mode button until all the other mode buttons light up, and

then release the button. The Mode button flashes. For example, hold TV for a TV until all

of the other mode buttons light. When you let go, TV flashes.

2 Press POUND (#) twice. Watch the mode light to determine your code. The mode button

flashes the number for each digit of the device code, with a pause between the groups of

flashes. A quick flash is for zero. For example, if the code is 570, the Mode button flashes

five times, pauses, flashes several tiems, pauses, and flashes once quickly.

For AUX mode: The first group of flashes tells you what the AUX mode controls. A quick

flash (zero) before the three-digit code is for a TV; one regular flash is for a DVD and/or

VCR; and two flashes for for a tuner, amplifier, or audio receiver.

For a satellite receiver programmed in AUX mode: The AUX mode button flashes the

same number of times as the address number.

For Limited Mode: If you have programmed a TV or DVR/VCR in Limited Mode, the

mode button flashes once at the end of the flash sequence.

Controlling a Tuner or Amplifier

Use the following remote control buttons to control a tuner, amplifier, or audio receiver.

When the remote control is set up as described on pages 66 and 75, press the AUX mode

button to set the remote to AUX mode. The AUX mode button stays lit for two seconds to

show you’ve set the remote to AUX mode. Make sure to keep the remote in AUX mode to

use the following buttons.

DVD