User Guide

PROGRAMMING THE REMOTE TO CONTROL A SECOND

ECEIVER IN AUX MODE

If you have another DISH Network satellite receiver installed, you can

use this remote in AUX mode to control it along with your new

receiver. When you program the remote to control the other receiver,

the remote will send out IR and UHF (not UHF Pro) signals to the

receiver. You can program the remote to control any other DISH

Network satellite receiver, except for following:

• TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942,

ViP222, ViP622 DVR, and ViP722 DVR

• DishPlayer 7100/7200

1 Turn on the other receiver. Use the SYS INFO button on the front

panel to open the System Information screen.

Write down the address shown:

2 Press and hold the AUX button until all the other mode buttons

light up, and then let go of the button. The AUX button flashes.

3 Press the 3 button.

4 Use the NUMBER PAD to enter the address you wrote in

step 1.

5 Press POUND (#). The AUX button blinks three times.

6 Press RECORD to make sure the address in the remote matches

the address on the receiver.

7 Press the plus (+) and

minus (-) sides of the

VOLUME button.

7 Press the plus (+) and

minus (-) sides of the

VOLUME button.

8 The equipment’s volume

changes and the AUX mode

button lights instead of the

TV mode button.

8 The TV’s volume changes

and the TV mode button

lights instead of the AUX

mode button.

Control Amplifier Volume Control TV Volume

6.3 Main Text.fm Page 7 Friday, February 15, 2008 10:17 AM