User Guide

Page 33
Optimize Your Remote Control(s)
Attach a UHF Attenuator (for optional accessory)
Stray UHF signals can block signals sent from a UHF Pro remote control to the
receiver. To help with this issue, you can obtain a 10 dB attenuator (available
from a consumer-electronics parts store).
Note: This will help keep out stray UHF radio signals, but also cut down on
how far away you can use the remote control from the satellite receiver.
1. Remove the UHF remote control
antenna from the receiver’s back
panel UHF Remote Antenna
input.
2. Hand tighten the attenuator onto
the UHF Remote Antenna input.
3. Reinstall the UHF remote control
antenna onto the attenuator. The
connector should be hand
tightened, and the mast kept
close to vertical.