User Guide

Chapter 2
Page 32
Receiver Description and Installation
TV distribution equipment devices may include coax panels, amplifiers or super
home nodes, and are available through many consumer-electronics companies.
Optimize Your Remote Control(s)
Change the Address
When you receive your system, the remote control(s) and the receiver have both
been set to communicate on address 1. However, because UHF radio signals can
travel long distances and go through walls, a neighbor’s UHF Pro remote could
control your receiver by mistake if they are set on the same address.
Note: You can use this procedure to change the Primary Remote Address for
the IR remote control on a nearby TV, if necessary. However, if you are using an
IR/UHF Pro remote to control
TV1, use the instructions on page 34 to change
the UHF Pro remote address.
To handle this situation, you can change the remote address on a UHF Pro
remote control and the receiver as follows:
1. Make sure you power on the TV and can view the screen.
2. Press the front panel SYSTEM INFO button to display the
System Info
screen.
The
System Info screen shows the Primary Remote Address.
Write down this address:
3. Press and hold the SAT button on the UHF Pro remote control for
about three seconds, until all of the mode buttons light up, and
then release the SAT button.
4. Use the remote control NUMBER PAD buttons to enter any number
between 1 and 16, but not the one that you just wrote down in step 2.
Write down the number you entered:
5. Press the POUND (#) button. If you entered the address correctly,
then the SAT mode button will flash three times.
6. Press the RECORD button on the UHF Pro remote control.
7. Make sure the
Pirmary Remote Address you see now on the
System Info screen is the same as the one that you entered in step
4. If it is not the same, the remote is not controlling the receiver.
8. Press the SELECT button to close the
Important System
Information
screen.
Confirming the Remote Control Address
1. Press and hold the SAT mode button for three seconds, until all of
the mode buttons light up, and then release the SAT button.
2. Press the POUND (#) button twice. The SAT mode button will
flash the same number of times as the address number (for
example, three flashes of the mode button means address 3).