User Guide

Page 31

Optional - Connecting VCRs to the System

The diagram below provides examples of how to connect VCRs to your satellite

TV system. Your particular installation may differ from these examples.

Connecting a VCR to the Nearby TV

1. Connect a coaxial cable from the CH 3-4 OUT output on the receiver to the

nearby VCR’s tuner input port.

2. Connect another coaxial cable from the output on the VCR to the nearby

TV’s tuner input port.

3. Plug in and turn on both the nearby VCR and TV.

4. Set the VCR output to Channel 3 or 4, as selected on page 27.

5. Tune the nearby VCR and TV to Channel 3 or 4, as selected on page 27.

6. You can place a

TV1 channel sticker (Channel 3 or 4, as selected in step 5)

on or near the nearby TV. This sticker will remind you which channel to use

on this TV to watch satellite-receiver programming. The stickers are located

in the inside front cover of this guide.

Optional - Connecting to an Over-the-Air Antenna or

Cable

If you want to receive channels from an over-the-air (OTA) antenna or cable in

addition to your satellite-receiver programming, connect the OTA antenna/cable

into your TV distribution equipment.

For the nearby TV receiving programming from

CH 3–4 OUT, the over-the-air

antenna cable needs to be connected to the

TV ANTENNA/CABLE IN port.