User Guide

Chapter 2
Page 30
Receiver Description and Installation
5. The receiver begins performing the Check Switch tests. When the receiver
finishes testing the switch, it displays the
Installation Summary screen.
6. Make sure that the information on the
Installation Summary screen
identifies your system correctly and shows all transponders for all satellites
in your system. Your screen may look different from the examples above,
depending on your the dish antenna system in use. (For example, existing
installations with two connections to
SATELLITE IN 1 and SATELLITE IN 2.
will display results in both columns of the table displayed on this screen.)
7. Select
OK to go to the Point Dish/Signal screen.
8. Select
Cancel to exit the Point Dish menu. An Attention screen will
appear, asking you if the mounting and positioning of your dish is complete
with a
Locked indication in the Point Dish screen. If your answer is yes,
select Yes. If you answer No, you should realign the dish antenna system.
9. After you select Yes, the receiver will begin downloading and installing a
software upgrade. You will see a Warning that
Vital program information
will now be downloaded into your receiver
. You will also see a status bar
indicating the progress of this upgrade. Do not interrupt this download.
10. Once the download of the upgraded software is complete, you will see a
message that your receiver’s memory is being upgraded with the new
software.
11. Do not disturb the receiver while the receiver’s memory is being upgraded.
Note: If you are installing other DISH Pro or DISH Pro Plus receivers, then
be sure to run the
Check Switch test on all of them, and allow each of them
to download and install the necessary software upgrade(s).
12. When the receiver has finished upgrading its memory with the new
software, you should then be watching live video on your connected TV.
Your dish antenna installation is now complete.