User Guide

Chapter 1
Page 16
Introduction
Quick Tour of Watching One Program While
Recording Another
*
The steps below show one of many ways to watch one program while
recording another.
1. Press GUIDE to open the
Program Guide. Find a program
you want to watch now.
2. Press SELECT to watch that program.
3. Press the RECORD button.
4. Select
OK.
5. Press the GUIDE button on the remote. Use the
Program Guide to find
another program that you want to watch now. Select that program. You
are now watching one program while recording another.
6. Press the RECORD button and select
OK when the pop-up message
displays. You are now recording two programs at the same time.
7. Press the DVR button on the remote control. The
DVR Events screen
will open. You should see the two current programs that are recording
indicated by the red dot next to the listings.
8. Select a program that you recorded in an earlier quick tour (that is, one
that is not recording now), and then select
Start.
9. You should now be watching a pre-recorded program while the receiver
is recording the other two.
* Note: This feature is enabled only for those installations that have two
RG-6 cables from the compatible LNBF or switch connected to both of the
receiver’s
SATELLITE IN ports. This feature is not supported for installations
with a single RG-6 cable connected to the receiver
SATELLITE IN 1 port.