User Guide

Chapter 3
Page 96
Using the System
5. Press the POUND (#) button.
The TV mode button flashes three times.
6. Press the SAT mode button.
7. Press the plus (+) and minus (-) sides of the VOLUME
button.
The TV’s volume changes and the TV mode button
flashes instead of the AUX mode button.
Testing the System
Starting a Test
Press the MENU 6-3 buttons on your remote control to access the Diagnostics
menu. You will see several options available for testing your DVR receiver.
Telephone Connection Test
This test checks that the receiver telephone connection is working. Select the
Connection option to begin the test. The receiver displays a message asking
you to wait until the test is done.
• If the telephone connection is correct, then the receiver displays a
Phone
Connection OK message.
• If the receiver highlights the
Done option, then select the Dial Out option so
the receiver can make a toll-free call to the Customer Service Center. Press
the remote control SELECT button to start the call. The receiver displays a
message asking you to wait until the call is done. When the call is done,
select the
Done option to exit the test menu.
• If the telephone line is not connected properly, then the receiver displays a
failure message. In this case, check the telephone connection and line, and
then repeat the test.
Note: If you have the receiver connected to a phone line with DSL (Digital
Subscriber Line) service, this may cause the test to fail. If so, you will need
to install a DSL filter between the receiver and the telephone jack on the
wall. You should be able to get a DSL filter from your DSL service provider
or your local consumer-electronics parts store.