User Guide
3
2
3
4
5
Decide if the remote is being used
for TV1 or TV2. If it is being used
for TV1, determine whether to use
IR or UHF signals for the remote.
Use UHF signals if you do not have
a clear line of sight between the
remote and the receiver.
Pull the remote battery cover off.
If your remote shows a “1” or a “2”
on the bottom, you can pull out this
key and ip it to the other number
(2 to 1 and 1 to 2). To separate the
key from the remote, insert your
thumbnail or a coin in the crease at
the bottom of the remote.
Remove the key by grasping
at the bottom.
Insert the key you wish to use to
designate the remote and slide into
place. Usually a 1 = TV1 and a
2 = TV2. Use the green 1 (no UHF
Pro markings) for TV1 IR. Use the
green 1 UHF Pro for TV1 UHF.
Continue to
Insert the Batteries on page 4.
A
B
AAA
AAA
AAA
AAA
Conguring the 6.4 Remote,
continued
Selecting the Remote Key, continued
UHFUHF
PRO