User Guide

31
Changing the Remote and
Receiver Address
Sometimes the receiver picks up UHF interference
from another receiver in the house or even a
neighbor’s. If you notice that your receiver is
changing channels or opening menus but you
are not using the remote control, changing the
address should x the problem.
Press SYSTEM INFO on
the receiver’s front panel.
Write down the TV2 remote
address shown on the
System Info screen.
Press and hold SAT on
your remote control, until all
the Mode buttons light up,
and then release SAT.
Add one to the address
that you wrote down in
step 2, and use the
NUMBER PAD to enter
that number (between 1
and 16).
Press POUND (#).
Press RECORD.
Press several buttons on
the remote to make sure it
is working as expected.
1
2
3
4
5
7
6