User Guide

Recovering Your Picture

Use the RECOVER button to return to watching

satellite programming if you accidentally change

channels or inputs on your TV, DVD, and/or VCR.

To best use this feature, you must set up SAT

Auto-Tune for your TV (see page 22) and for your

DVD/VCR (see Setting Auto-Tune for DVD/VCR

on page 24).

Note: RECOVER only works if the remote control has been

set up to control the TV and/or DVD/VCR, if connected.

If the RECOVER button is used, the TV channel

programmed for SAT Auto-Tune is also the channel that

is sent to the TV. If SAT Auto-Tune is not programmed,

RECOVER rst tries to tune your TV to channel 3, then

channel 4, and then other video inputs with each press of

the RECOVER button. If SAT Auto-Tune is programmed,

RECOVER tries to tune your TV to the channel given in

SAT Auto-Tune and then other video inputs with each

press of the RECOVER button. You may need to press the

RECOVER button up to 30 times to recover your satellite

TV video. If SAT Auto-Tune is not set up, RECOVER only

tries channels 3 and 4.

Press and hold RECOVER until

all Mode buttons light up.

If you see the System Info

screen, proceed to step 4.

Otherwise, continue to step 3.

Press RECOVER again and

wait until the Mode lights stop

ashing. If you see the System

Info screen, go to step 4. If not,

repeat this step until you see

the System Info screen.

Press SELECT to resume

watching TV.