User Guide

20
Displaying Device Code and
Remote Address
To identify the device code that your remote
control is using or to display the remote control
address, complete the following steps:
Press and hold the Mode button
for the device until all the Mode
buttons light up. Release. The
selected Mode button ashes.
To display the remote control
address, press and hold the SAT
Mode button until all the Mode
buttons light up. Release. SAT
ashes.
Press and release
POUND (#) twice.
The Mode button ashes a
number of times corresponding
to the value of the stored device
code. If Limited Mode is used,
the last ash represents Limited
Mode. For example, if the stored
device code is 593, the Mode
button ashes ve times, pauses,
ashes nine times, pauses, and
ashes three times. A quick ash
is for zero.
If SAT was pressed to display the
remote address, the SAT Mode
button ashes 1 to 16 times,
giving the remote address.
For AUX mode: The rst group of
ashes tells you what the AUX mode
controls, then the following ashes
tell you each digit of the device’s code.
— 0 for second TV
— 1 for second DVD/VCR/BD
— 2 for tuner, amplier, or audio
receiver
Record the stored device code
in the Reference Table on the
inside back cover.
3
2
1
4