User Guide

Note: Use these steps to convert your TV1 remote to

UHF with a DISH 322 receiver. Do not do these steps

if you are using the 4.4 remote with the blue 2 key.

If you set up your DISH 322 to operate the

side using UHF Pro and you have a second

TV connected to your DISH 322 receiver, the

two UHF Pro remotes for this receiver will interfere

with each other when operated at the same time. This

may prevent the remotes from operating the receiver

momentarily. If you want to avoid this possible conict,

program a different address into one of the remotes.

For more information see Changing the Remote and

Receiver Address on page 25.

To convert the TV1 4.4 remote to UHF, complete the

following steps. If these steps are not completed, your

TV2 remote control will control the side of your

receiver.

Using an already congured TV1 remote control,

select MENU-System Setup-Installation-TV1

UHF Pro Setup to open the TV1 UHF Pro Setup

screen.

Select Enable and select Done.

Press the SYS INFO button on the remote control

to open the System Info screen.

Move the highlight to the address for the Primary

Remote Address as shown below. This is

important—if you do not do this, your remote

changes the receiver’s Secondary Remote

Address and causes your TV1 remote control to

control the side of your receiver.

Using the UHF Pro remote control that you want

to control TV1, ip the key on the bottom of the

remote to the green 1 UHF Pro key.

Continue with Step 5 of Making 4.4 UHF Remote

Work with Receiver on page 5.

Making 4.4 UHF Remote Work

with DISH 322 Receiver

Cancel

E7DFA513:0560A2F6

UHF Pro

Location ID

Primary Remote Address

Secondary Remote Address

Help

Done