User Guide

Receiver Customization

Sending Discrete Power On and Off

SENDING DISCRETE POWER ON AND OFF

Discrete power ON and power OFF IR commands are used when programming macro

commands into universal remotes. Using an ON-only or OFF-only command is more

effective than a toggle ON/OFF command when trying to make sure the dish antenna is

reliably in one state or the other. To send a discrete power ON or OFF command, use the

following steps:

1 Program the remote control to control all the devices that you would like to control.

2 Press SAT until all the Mode buttons light up.

3 Press POWER.

4 Press VOLUME UP for discrete power on. Press VOLUME DOWN for discrete power off.

5 Press any button to end this procedure.

QUESTIONS

• My remote doesn’t control my receiver or other components. What should I do?

– Put the remote control is in the correct mode.

– Check the batteries.

– Check the remote control address.

Program the

remote control

Press

POWER

Press

SAT Mode

until all mode

buttons light up

Press VOLUME UP

for discrete power on

or press VOLUME DOWN

for discrete power off

Press any

button

to end this

procedure