User Guide

28
Discrete Codes
Discrete On and Off IR-only remote-control
commands are used by installers when
programming macro commands into universal
remotes. Using an On-only or Off-only command
is more effective than a toggle On/Off command
when trying to ensure the receiver is reliably in
one state or the other.
Program the DISH Network
remote to the desired
remote address (see
Changing the Remote and
Receiver Address, page
29).
Hold SAT until all Mode
buttons light, then release
the button.
Press POWER (not TV
POWER).
Press VOLUME UP for
discrete power on. Press
VOLUME DOWN for
discrete power off.
Press any other button
when done to end this
procedure.
1
2
3
4
5
SAT