User Guide

27
Learning from Another
Device’s Remote, continued
On your DISH Network remote, press the button
you want to teach.
On the original device’s remote control, press
and hold the button you want learned. If the DISH
Network remote learns the command, the Mode
light blinks off and then back on. If the Mode
light blinks three times or remains lit, the DISH
Network remote did not learn the command.
You may need to press the button on the original
remote several times for the DISH Network
remote to learn the command.
After a button has learned a command
successfully, repeat step 5 and step 6 until all
commands you want have been learned.
Press one of the Mode buttons on the DISH
Network remote to end the learning sequence.
This saves all the commands for that mode and
exits learning to return to normal remote control
operation.
To cancel learning, do not press any buttons on
either remote control for at least 30 seconds.
The DISH Network remote control times out and
returns to normal operations.
Note: If the remote control batteries are too low
for learning, all the Mode buttons blink quickly
eight times. Learning ends without saving learned
commands, and the remote returns to normal
operation. Change the batteries.
Note: No learned commands are saved if the
DISH Network remote controls times out before
completion.
5
7
6
8