User Guide

26
Place both your DISH Network remote and the
original equipment’s remote control on a fl at,
stable surface.
• If you’ve found a code for that device, fi rst
program the code using the instructions for
Entering a Code on page 13 or Scanning
the Remote Database on page 12. If
the device code has been programmed,
press and release RECALL, then hold the
RECORD button for about three seconds
until the Mode button is lit again. The button
remains lit while learning.
• If the device code has not been
programmed for that device or if you are
unable to fi nd a code, press and hold the
RECORD button for about three seconds
until the Mode button is lit. The button
remains lit while learning.
On the DISH Network remote, press and hold
the Mode button for your equipment for about
three seconds until all the Mode buttons light up,
and then release it. Your selected Mode button
blinks.
Point the front of the original device’s remote to
face the small square (IR window) on the front,
left-hand side of your DISH Network remote, as
shown above.
Learning from Another
Device’s Remote, continued
3
4
2