User Guide

Learning From Another

Device’s Remote

Use this procedure if you are unable to ﬁ nd a code

that allows your DISH Network remote to control

your device. This procedure is also applicable if, after

you have programmed your DISH Network remote

to control your device (in TV, DVD, or AUX modes),

some of the commands are not functioning as you

expect. The learning function of your DISH Network

remote control can support these commands.

The remote control can learn commands in two ways:

• You can follow the instructions for using

equipment codes to program a speciﬁ c mode,

and then learn commands that add new or

overwrite existing functions of the remote

control’s buttons in this mode. For this type

of learning, any button without a learned

command keeps the previous command (if any)

for that equipment code.

• Each button on this remote learns a command

from the equipment’s original remote control.

For this type of learning, any button without

a learned command keeps the previous

command (if any) for that equipment code.

To teach your DISH Network remote control speciﬁ c

commands for your equipment, complete the

following steps.

Ensure the DISH Network remote control is

programmed to the desired remote address (see

page 5 or 6).