User Guide

17
SAT Auto-Tune
Setting SAT Auto-Tune Channel
Most snowy, blue, or black screen issues occur
because the TV is set to the wrong channel. Using
the SAT Auto-Tune feature helps prevent that issue
from occurring on TVs connected to the receiver’s
modulated output (usually TV2). Use SAT Auto-Tune
to program the correct TV channel for satellite viewing
into the remote control. When the SAT button is
pressed, the remote sends that channel to the TV.
This feature is enabled by default; however, if you want
to use this feature, the channel must be programmed
by following these steps.
Make sure the remote control
operates your TV.
Press and hold TV for three
seconds until all four Mode
buttons are lit.
Press STAR (*).
Enter the channel used for
viewing (up to three digits
in range of 002 to 125), for
example channel “010.”
Press POUND (#). The Mode
button fl ashes three times to
indicate programming was
successful.
Press SAT. The channel
changes.
1
2
3
4
5
6
SAT