User Guide

POSITION BUTTON

Press the POSITION button to move the PIP window to different

positions on the TV screen. Each time you press this button, the

PIP

window moves to a different position. See your receiver user’s guide

for more information on using the PIP feature.

SWAP BUTTON

Press the SWAP button to swap the video in the main display with the

video in the PIP window. See your receiver user’s guide for more

information on using the PIP feature.

RECOVER BUTTON

Use the RECOVER button if you accidentally change the channel or

video input on your TV and cannot get the picture back from your

satellite receiver. When you press the RECOVER button as described

in the following section, the remote control sends commands to your

TV and VCR (if set up) to change channels or video inputs to try to get

you back to watching satellite programming.

Note: RECOVER only works if the remote control has been set up to

control the TV and/or VCR, if connected (see Setting Up to Control

Other Devices on page 11).

This procedure works only if you have accidentally changed the TV

channel or video input. It does not recover lost satellite signal (see

Troubleshooting the Kit for troubleshooting information). The

following setup is required to use the RECOVER button:

• The remote control must be set up to control the TV and, if

installed, the VCR (see your satellite receiver’s User Guide or the

Installation Instructions).

• If a VCR is installed, make sure it is connected as shown in your

satellite receiver’s User Guide.

To use the RECOVER button, complete the following instructions:

1. Press and hold the RECOVER button until all four mode buttons

light, and then let go of the button. The SAT mode button flashes

twice and then all four mode buttons flash three times.

2. Press the RECOVER button. Wait for the TV or VCR mode

button to flash once and then all four mode buttons to flash once.

Pyramid.book Page 23 Wednesday, February 16, 2005 4:00 PM