User guide
Chapter 4
Dish Antenna
Installation
12.
You
should see the
Point Dish/Signal
menu. If not,
open the
Main Menu
,
select
System Setup
, then
Installation
, then
Point Dish/Signal
(press
MENU
and then press
6
-
1
-
1
on the
remote).
13.
Select
Check Switch
. The
Check Switch
screen will
open.
14.
Select Check
or
Test
. The receiver shows you a message that it is checking
the switches.
15.
When the check
switch
procedure finishes, you will see an
installation
summary screen similar to the
one below.
In the
Satellite
line, you will see
“Conn.” In the
Device
line, you
will “Twin”
twice.
This indicates that your
receiver has
confirmed the
connection
with
your DISH Pro Twin LNBF
is
working. The Transponder line
may show two “Xs.” This
is OK
and does
not
indicate
a problem with the
receiver.
Tip: Have one
person aim
the dish
while
another
watches the signal
strength or listens
to the signal tone.
16.
Select
Cancel
or
OK
to
return to the
Point Dish/Signal
screen. Make sure
the check mark is next to
119 West
.
If not, move
the highlight
to
119 West
and press
SELECT
.
Notice the
signal
strength bar. This is used to
help
you
aim the
dish by
showing the
strength
of the signal you are
receiving. Look at
the
signal strength bar while you
aim
the dish.
Don’t
stand
in
front of
the dish while you aim it,
because your body will
block the
satellite
signal.
After you adjust
the aim,
let go of
the dish so that
you can get a good signal
reading
after the dish settles back
in place by itself.
Do not
change the skew setting
.
Page 80