User guide

DISH Pro Wiring Diagrams
DISH 500, DISH 300, One DISH Pro Twin LNBF, One DISH Pro
Single LNBF, One DISH Pro Compliant Splitter, Two DISH Pro
21 Switches
This diagram leaves out grounding to be clear. Make sure
you ground the system per the National Electrical Code
(NEC) and all local electrical codes.
*
* When using a DISH Pro
compliant splitter to split the signal
from a DISH Pro single LNBF, the
receiver tuner whose DP21 switch is
connected to the passing side of the
splitter must be plugged into a live
power outlet at all times. If not, the
DISH Pro single LNBF will not
have any power and will not be able
to provide satellite signal to the
other receiver tuner.
When you set up your system following this diagram and run Check Switch
the Installation Summary screen should look similar to the one shown
below.
Page 89