User guide

Chapter 4
Dish Antenna Installation
8. Select Check Switch from the Point Dish menu. When the Check Switch
screen opens, select Retest .
9. When Check Switch is complete, you will see an Installation Summary
screen similar to the one shown next. It will show a connection (“Conn” next
to satellite) and Single device under 1 (Dish Input). It may also show an X
on the Transponder line . This is okay and does not mean there is a problem
with the system.
10. Press CANCEL to exit back to the Point Dish menu.
11. Point the dish for the strongest possible signal, following the instructions
that came with it.
12. Connect tow RG-6 cables between both ports on your DISH Pro Twin LNBF
and your switch(es) using the switch instructions and the DISH Pro wiring
diagrams that start on page 85.
13. Select Check Switch from the Point Dish menu. When the Check
Switch menu opens, select Retest . When the procedure completes, you will
see the Installation Summary screen again. This time you should see
confirmation for all satellites your dishes are pointed at, and “Satellite
reception verified.” You should also see that the switch(es) in your system
has been correctly identified.
Refer to the DISH Pro wiring diagrams for examples of installation
summary screens.
14. Press CANCEL to exit this menu, and then Cancel to exit the Point
Dish screen. If you have any other receivers in your system, make sure you
run Check Switch on each of them, and allow each to take the software
upgrade, as needed.
Page 84