User manual

Page 93
Installing a DISH 500 Antenna
10. Press CANCEL to exit back to the Point Dish/Signal menu.
11. Point the dish for the strongest possible signal, following the instructions
that came with it and the DishPro wiring diagram s that start on page 94.
12. Connect any switches in your system, using the instructions which came
with the switch(es).
13. Select Che ck Switch from the Point Dish/Signal menu. When the
Check Switch menu opens, select Check or Test. When the procedure
complete s, you will see the Installation Summary sc reen again. This
time you should see confirm ation for all satellites your dishes are pointed at,
and “Satellite reception verifie d.” You should also see that the switc h(es) in
your system has been correctly identified.
Refer to the DishPro wiring diagrams for e xamples of installation summary
screens.
14. Press CANCEL to exit this menu, and then Ca ncel to exit the Point
Dish/Signal screen.
If you have any other receivers in your system, m ake sure you r un Che ck
Switch on each of them, and allow each to take the softwa re upgra de, as
needed.