User manual

Page 92
Chapter 4
Installation Instructions
2. Make sure the check mark is next to the sa tellite your dish w ill be pointed
toward.
3. I f your
Point Dish/Signal screen looks like the one on the left, continue to
step 4. If your
Point Dish/Signal screen looks like the one on the right,
select
Peak Ang les and the Dish 300 option.
4. Select
Peak Angles.
5. Use the number buttons on the r emote to enter your ZIP code to ge t the
necessary azimuth and elevation. Write these num bers down in the spaces
provided in the m argin.
6. Mount the dish antenna following the mounting instructions that came with
it.
7. C onnect an RG-6 cable from the DishPro S
AT IN connection on the receiver
directly to the DishPro LNBF on the Dish 300.
Make sure there a re no
multi-dish switches between the LNBF and the DishPro receiver.
8. Select
Check Switch from the Point Dish/Signal menu. W hen the Check
Switch
screen opens, select Che ck.
9. Whe n
Check Switch is complete, you will see an Installation Sum m ary
screen similar to the one shown next. It will show a connection (“Conn”
next to satellite) and
Single device under 1 ( Dish Input) . I t may also show
an X on the Transponder line. This is okay a nd does not mean there is a
problem with the system.
Azimuth:
Elevation: