User manual

Page 90
Chapter 4
Installation Instructions
19. You are now ready to verify reception f rom both satellites. Select the
Check Switch option. When the Check Switch menu opens, se lect
Check or Test. The receiver shows you a message that it is chec king the
switches. When the procedur e is f inished, you will see an Installation
Summary screen. This screen may look diff erent than the one shown
below. However, you must see that you have signals from both the 110
West and 119 West Satellites, you see “All” twice in the Transponder
line, and the message “ Satellite reception verified. Press CANCEL or OK
to e xit this menu.”
20. I f you do not see “ 110” under
Dish Input 2:
• Make sure the skew angle you wrote down on pa ge 84 is exactly the
same a s the skew angle you set in ste p 5 on page 86. If it is not, rese t the
skew angle as described on page 86. After you reset the skew angle , go
back page 89 and sta rt over from step 16.
• If “ 119” is shown under
Dish Input 2, m ove the dish a pproximately 9°
to the east a nd restar t the procedure at step 12.
21. Look at the P oint Dis h/Signal menu. If you have good signal strength
with the check mark in 119 West, move the check mark to 110 West.If
you ha ve good signal strength on 110 West,gotostep22.
If you do not ha ve good signal strength with the check mark in 110 West,
go ba ck to Step 17, and fine-tune the dish but with the check mark in 110
West inste ad of 119 West. While the 110 West and 119 West signals will
not be equal, you should be able to fine-tune the dish until you have the
strongest possible signal from both satellites.
22. S elect Canc el to e xit the Point Dish/Signal menu. An Attent ion screen
will open asking the m ounting and positioning of your dish is com plete with
a “Locked” indication in the P oint Dish/Signals scree n. If the answer is ye s,
select Yes.
If the answer is No, you w ill need to re point your dish following the
preceding steps until the mounting and positioning is complete and you do
have the “Locked” indication.