User manual

Page 88
Chapter 4
Installation Instructions
below. Be sure there are no multi-dish switches between the LNBF and the
receiver.
10. Attach the LNB F to the Y-bracket using the two LNBF scre ws.
11. Slide the dish assembly down onto the mast. Make sure the pivot bolt rests
on the top of the mast. Turn the dish assembly so that it points in the genera l
direction of the satellites, using the azimuth angle from 84.
12. You should see the
Point Dish/Signal menu. If not, open the Main Menu,
select System Setup,thenInstallation,thenPoint Dish/Signal (press
MENU andthenpress6-1-1 on the remote).
13. S elect
Check Switch.TheCheck Switch screen will open.
14.
Select Ch eck or Test. The re ceiver shows you a message tha t it is checking
the switches. Go to ste p 15.
15. Whe n the c heck switch pr ocedure finishes, you will see an installation
summary scre en similar to the one below. In the Satellite line, you will see
“Conn.” In the Device line, you will “Twin” twice. This indicate s that your
receiver has confirmed the connection with your DishPro Twin LNB F is
working. The Transponder line may show two “Xs.” This is OK and does
not indicate a problem with the rec eiver.
Connect to Port 1. It’s on
the left when the LNBF is
pointed towards you
Port 1
Port 2