User manual

Page 86
Chapter 4
Installation Instructions
4. Assemble the sa tellite dish as shown below, except do not attach the Y-
bracket or LNBF a t this time.
5. Loosen both skew bolts a nd set the skew by rotating the dish mounting
bracket to align the red mark with the required angle on the skew scale
which you wrote down on 84. Tighten the skew bolts secur ely to keep the
dish from rotating. Once the skew is set, do not try to fine-tune this angle
when aimin g the dish.
6. Set the elevation by tilting the dish mounting bracket to align the red edge
with the required angle from page 84 on the elevation scale. Tighten the
elevation bolts, but do not tighten the pivot bolt at this time.