User manual

Page 84
Chapter 4
Installation Instructions
2. Make sure that the remote control batteries a re fresh, and are installed
properly. If needed, make sure that the remote is in SAT mode to control the
satellite receiver.
3. Turn ON the television and receiver.
4. Display the
Point Dish and Signal Strength menu by pressing MENU and
and then 6-1-1 (unless the receiver already displays this m enu).
5. I f you P oint D ish/Signal screen looks like the one on the left, continue to
step 6. If your Point Dish/Signal screen looks like the one on the right,
select
Peak Ang les .
6. Enter your ZIP code in the
ZIP Code field.
7. Select the
Dish 500 option.
8. The m enu displays the azimuth, elevation, and skew angles. Wr ite down
these numbers in the blanks provided in the m argin.
9. Select Cancel to exit out of this menu and retur n to the Point
Dish/Signal menu.
10. Go to Mounting the Dish on page 85.
Azimuth:
Elevati on :
Skew: