User manual

Chapter 2
Page 26
Parts of the System
Change the Address
Because UHF signals travel long distances and go through wa lls, a
neighbor’s remote c ould control your receiver by mistake. To handle this
problem, you can change the address on the rem ote and rec eiver as follows:
1. Make sure you turn on the TV and receiver.
2. Ope n the
Important System Information m enu by
pressing the rec eiver ’s front panel SYS INFO button.
3. The
Important S ystem Information menu shows a
Remote Address.
Write down this numbe r:
4. P ress a nd hold the SAT mode button about three seconds, until
all the mode buttons light up, and then let go of the SAT button.
5. Use the number buttons to enter any number from 1 to 16, but
not the one you wrote in step 3.
Write down the number you enter:
6. P ress the POUND (#) button. If you entered the address c orrectly, the
SAT mode button f lashes three times.
7. P ress the RECORD button.
8. M ake sure the
Remote Address you see on the Important System
Information
menu now is the sa me as the one you entere d in step 5. If
the addresses are not the same, repeat step 7.
9. To c heck the address in the remote control, press and hold the SAT
mode button for thr ee seconds. Then, let go of the SAT button, and
press the POUND (#) button twice. The SAT mode button flashes the
same number of times as the address you entered in step 5.
Press the SELECT button to close the
Important System Information
menu.