User manual

Page 119
Test the System
TEST T HE SYSTEM
START ANY TEST
1. Press the MENU button.
2. Select the
System Setup option.
3. Select the
Diagnos tics option.
Note: “Diagnostics” are just “tests.”
4. Select the option for the test you want to do.
Note: If we upgrade the receiver software,we may add new te sts.
TEST THE PHONE CONNECTION
1. Make sure you connect a phone line to the receiver’s back pa nel
PHONE JACK.
2. Select the
Connection option.The receiver
displays a message that asks you to wait until
the test is done.
• If the phone c onnection is oka y, the rec eiver displays a
message that says so.
• If the rec eiver displays a message that
it needs to make a toll-free call to the
Customer Service Center, select the
Dial Out option.The receiver displays
a message that asks you to wait until
it finishes the call. When t he receiver finishes the call, select
the
Cancel option.
• If you didn’t connect the phone line right, the receiver
displays a message that says so. Check the phone connection
andthendothetestagain.
Note: If you have a Digital Subscr iber Line (DSL), you m ay
need to install a DSL filter between the receiver and the
tele phone wall jack, and then do the test again.