User manual

Page 98
Chapter 4
Installation Instructions
Two Dishes, One D ishPro Tw in LNBF, One DishPro Single LNBF,
One DishPro Compliant Splitter, Two DishPro 21 S witches, Two
Receivers
This diagram leaves out gr ounding to be clea r. Make sure you
ground the syste m per the N ational Electrical Code (NEC) and all
local electrical codes.
When you set up your system following this dia gram and run Check Switch
the Installation Summary scre en should look sim ilar to the one shown
below.
*
* When using a DishPro compliant
splitter to split the signal from a
DishPro single LNBF, the r eceiver
whose DP21 switch is connected to
the passing side of the splitter must
be plugged into a live power outlet
at all times. If not, the DishPro
single LNBF will not have any
power and wi ll not b e able to
provide satellite signal to the other
receiver.