Programming instructions

Remote Controls - TV2 IR Converter 13 - 61
Description Procedure
The remote
control does
not operate
the satellite
receiver.
6. Open the System Info screen (refer to the receiver’s User Guide). Look at the
Remote Address eld, and press the remote control’s RECORD button.
Exit the System Info screen, then test to see if the remote operates the receiver.
7. For IR remotes, verify there is no IR interference. Point the remote control directly at
the receiver and try to operate it. Be sure there are no solid objects in the way, or lights shining
directly on the front of the receiver.
Turn off orescent lights in the room to reduce the chance of interference, then try to operate the
receiver.
8. For UHF and UHF Pro receivers, verify the remote control antenna is connected to the REMOTE
ANTENNA port on the back panel of the satellite receiver, and is not touching any other
equipment.
Try moving the antenna. Review UHF/UHF Pro Remote Control Reception Tips.
9. Perform a front panel reset by pressing and holding the POWER button on the front panel of
the receiver for ve seconds. If the problem continues, turn the receiver off, unplug it from the
electrical outlet and wait 30 seconds, then plug it back in. Turn the receiver back on and see if
the remote control operates the receiver.
10. Some LCD TVs can cause interference with the IR remote control signal. This can be resolved
by using UHF instead of IR. See Upgrading TV1 to UHF Pro for more information.