Programming instructions
Extending UHF and UHF Pro Remote Control Range 13 - 47
Extending UHF and UHF Pro Remote Control Range
This section provides ways of extending UHF and UHF Pro remote control range to make remote controls work reliably in
difcult installations, where attempts to improve remote control range have been unsuccessful using easier methods.
The solutions shown use additional approved parts to “back-feed” the remote control antenna onto the same cable as
the HOME DISTRIBUTION (CH 21-69 or 73-125) Out or CH 3-4 Out for the distant TV location. This allows the remote
control antenna to be placed in the room with the TV, extending the range of the UHF or UHF Pro remote control.
Installation Diagrams
The following installation diagrams are the approved congurations for extending the UHF and UHF Pro remote control
range. Choose the diagram that best matches your installation and follow it closely.
Note: If an over-the-air antenna is installed, the remote control signal cannot be combined onto the same cable as the
over-the-air signal.