Programming instructions
Remote Controls - Two-Way Remote 13 - 41
Using the System Wizard
Opening the System Wizard
1. Press and hold “0” (1. zero) on the remote control. Note: If you move the remote control, or the IR sensor on the
receiver is blocked, you will get an error message.
2. System Wizard opens.
Pairing Conrmation
1. Access the System Wizard
2. If remote is paired already, A screen will pop up conrming this. Select Continue to return to programming.
Note: from this screen you can select Advanced to back up settings, or Restore Remote or Restore Receiver.
3. If the remote is not paired, a screen will appear asking you to conrm settings and select continue to pair the remote
control to the receiver.
4. Select Continue
5. If you need to change settings, for example to TV1 UHF Pro, select Recongure.
6. The Setup is Complete screen appears
7. Select Continue to return to programming