Programming instructions
Remote Controls - Two-Way Remote Controls (20.0 and 21.0) 13 - 37
Two-Way Remote Controls (20.0 and 21.0)
The two-way remote controls (Models 20.0 for IR, and 21.0 for UHF Pro/IR convertible) provide many benets, including:
• A “System Wizard” used during installation (or for replacement receivers) provides quick and easy remote control and
receiver setup. Press and hold 0 to activate.
• Two-way communication between the receiver and the remote control.
– The receiver stores remote control information to update replacement remote controls, and the remote control
stores receiver information to update a replacement receiver.
– The receiver detects if the wrong remote control is being used.
• The remote can “learn” codes from another device’s remote control (for example, a TV or DVD player), and add those
codes to the remote control.
• Easy extended remote address entry: for codes 1 to 28, simply press and hold SAT until all the mode lights are lit,
enter the number, and then press POUND (#).
• No keys are used to change the remote to operate via IR or UHF Pro. Uses a switch inside the battery compartment.
Note: these remotes cannot output legacy UHF.
Considerations
• The typical ways to program the remote control such as address and device codes, Limited Mode, and Recover will
work with these remote controls.
• Mode lights ashing after pressing and holding SAT indicates a low-battery condition.