Programming instructions

Remote Controls - SAT Auto-Tune 13 - 36
Compatible Remote Controls
• 5.3 IR*
• 5.4 IR
• 6.3 IR/UHF Pro*
• 6.4 IR/UHF Pro
• 20.0 IR
• 21.0 IR/UHF Pro
Considerations
• SAT Auto-Tune is disabled by default on the 5.3 and 6.3 remote controls.
• SAT Auto-Tune is enabled by default on the 5.4, 6.4, 20.0, and 21.0 remote controls.
• For SAT Auto-Tune to function correctly, the correct channel for the installation must be
programmed into the remote using the steps under Setting SAT Auto-Tune Channel.
• SAT Auto-Tune can only send a channel to the TV, not an input. Because of this, SAT Auto-
Tune is most useful for TV2. If used for TV1, channel 3 or 4 should be programmed using the
steps under Setting SAT Auto-Tune Channel.
• The TV channel programmed for SAT Auto-Tune is also the channel that will be sent to the
TV if the RECOVER button is used. The steps in Setting SAT Auto-Tune Channel can also be
used in VCR mode to program the channel sent to a VCR during the Recover process.
*Earlier versions of the 5.3 and 6.3 remotes (part numbers 142301, 142037, and 143129) do not
support SAT Auto-Tune