Programming instructions
Remote Controls - Remote Control Programming 13 - 24
3. Begin to count the ashes—the mode button ashes a number of times for each digit of the device code, with a
pause between the groups of ashes. A quick ash is zero. If Limited Mode was programmed for a TV or VCR, the
mode button ashes once at the end of the ash sequence. For AUX mode, the rst group of ashes tells you what
the AUX mode controls. A quick ash (0) before the three-digit code is for a TV, one regular ash is for a VCR/DVD,
and two ashes is for a tuner or amplier. If a satellite receiver was operated using AUX mode, the AUX mode button
will ash the same number of times as the receiver’s address number.
Scanning for Device Code (Power Scan)
Use the steps below to scan the remote control’s memory for the code that operates the device (for example, TV).
1. Turn the device on.
2. Press and hold the appropriate mode button on the remote control until all mode buttons light up, then release. The
mode button ashes.
3. FOR AUX MODE ONLY: Press 0 for a second TV, 1 for a second VCR or DVD, or 2 for a tuner or amplier. Then
press the STAR/FORMAT (*) button.
4. Press POWER (not TV Power).
5. Press only UP ARROW (or just DOWN ARROW, but not both) repeatedly until the TV turns off—a new code is sent
each time you press the button.
6. Press POUND (#).
7. Turn the device on and conrm the remote operates it.
Note: Power Scan may work faster if you rst use the steps in Entering a Code Directly to enter code 500. If starting at
code 500, use only the UP ARROW during Power Scan, since code 500 is the bottom of the database. This tip is not
applicable to the 20.0 and 21.0 remote controls.