user manual

Page 6
On the existing router or gateway, disconnect the Ethernet cable for an existing piece of
equipment connected to an
ETHERNET (or LAN) port. This equipment will be connected to the
Ethernet switch in step 2, below.
Note: Do not disconnect the cable connected to the router or gateway port labeled BROADBAND,
INTERNET, or WAN.
Connect the Ethernet cable disconnected in step 1 to an available
ETHERNET port on the Ethernet
switch. Refer to the Ethernet switch’s installation instructions for any additional instructions and
special considerations. If the Ethernet switch has a power adapter, connect it and plug it in
according to the switch’s instructions.
Connect an Ethernet cable to the
ETHERNET (or LAN) port on the router or gateway that was made
available in step 1.
Connect the other end of the Ethernet cable to an available
ETHERNET port on the Ethernet switch.
Verify that the personal computer and any other equipment connected to the Internet connection
continues to function properly after it has been connected to the Ethernet switch. Connect the
DISH Network satellite receiver using the steps in Connecting the Satellite Receiver to an
Available Ethernet Port on page 7.