User guide

lPage 69
Installing a DishPro DISH 500 system
6. Select Check Switch.The Check Switch screen will open.
7. Select Check. The receiver shows you a message that it is checking
the switches.
8. When the check switch procedure finishes, you should see an
installation summary screen similar to the one shown on the
following page. In the Satellite line, you should see the word
“Conn,” twice. In the Device line, you will see the word “Twin”
twice. In the LNBF line, you should see “twin-1.” This indicates that
your receiver has confirmed the connection with Port 1 on your
DishPro Twin LNBF is working. If your Installation Summary
screen matches this, you can go directly to step #10. If not, do one of
the following:
• If “Xs” appear in the Satellite line, recheck and tighten all the
connections in your system, and then select Retest to run Check
Switch again.
•If“Twin-2”isintheLNBF line, your receiver is connected to
Port 2 of the DishPro Twin LNBF. Disconnect the cable and
reconnect it to Port 1 of the LNBF, and then select Retest to run
Check Switch again.
• If you happened to pick up a satellite at this point, you may see
“110” or “119” in the Satellite line.
• If “119” shows under Dish Input 1,thengotostep#10.If
“119”shows under Dish Input 2, move the dish about 9
degrees to the east, and then select Retest to run Check
Switch again.
• If “110” shows under Dish Input 2,then go to Step #10. If
“110” shows under Dish Input 1, move your dish about 9
degrees to the west, and then select Retest to run Check
Switch again.
Tip: If, by acci-
dent, a satellite
is detected
through the
wrong side of
the LNBF, the
dish needs to be
turned to line up
the satellite sig-
nal to the cor-
rect side of the
LNBF.