User guide

Page 68
Installation Instructions
Chapter 4
1. Thread the RG-6 coaxial cable through the mast (optional),
support arm and the Y-bracket. This cable should be long enough
to run from your receiver to your LNBF. See Grounding the
System on page 95 for detailed cable installation instructions.
2. Connect the RG-6 cable from the DishPro Satellite In
connection on the back of the receiver directly to port 1 of the
DishPro Twin LNBF, as shown below.
Important: Be sure there are no multi-dish switches between the
LNBF and the receiver.
3. Attach the LNBF to the Y-bracket, using the two LNBF screws.
4. Slide the dish assembly down onto the mast if not already
installed. Make sure the pivot bolt rests on the top of the mast.
Turn the dish assembly so that it points in the general direction of
the satellites, using the azimuth angle from page 65.
5. You should see the Point Dish/Signal menu. If not, open the
Main Menu, select System Setup,thenInstallation,then
Point Dish/Signal or press 6-1-1 on the remote.
Connect to Port 1. It’s on
the left when the LNBF is
pointed towards you
Port 1
Port 2